• 1
• 2
• 3
• 4
• 5

پیاده سازی مدل باتری لیتیوم یون با نرم افزار متلب‎ (matlab )

فرمت فایل های ارسالی :‏‎ ‎

LiFePO4_PlecsViewer.slx

LiFePO4.slx

توضیح فایل :‏

Li-ion battery model

The LiFePO4 battery model developed on the basis of experimental data

The LiFePO4 battery model has been developed in the PLECS toolbox. The model of electrochemical cell has been created on the basis of the characteristics of Li-ion battery determined experimentally. The Winston Battery Cell LYP40AHA has been used in the study. Battery model has been developed to reflect the battery voltage during discharge at various condition. Voltage characteristics take into account the change in battery voltage caused by state of charge, temperature and current. The model is dynamic, i.e. it reflects the transient state of battery output voltage.

Performed studies allow to presume that the battery model adequately reflects the LiFePO4 behaviour in the ranges of:

- temperature 0C - 40°C

- cell voltage 2.5V - 3.6V

- C-rate current 0-2C

The parameterisation of the model allows to specify a battery pack with a defined cell capacity and number of cells in series.

There is not possible to model pure variable resistors in PLECS, so a capacitive coupled variable resistor with very small capacitance has been used to model a series resistance.

در صورت تمایل به دریافت فایل فوق در مدت 10 دقیقه اینجا کلیک کنید

نگارش پایان نامه و مقاله + شبیه سازی ‏‎ ‎‏در تمام مقاطع دانشگاهی‎ ‎پذیرفته می شود

‏در صورت ‏تمایل ‎ ‎ عنوان و جزئیات پروژه خود را در قسمت نظرات‏‎ ‎این پست ‏‏اعلام فرمایید‎. ‎‎ضمنا ‏می توانید اطلاعات درخواستی خود را نیز ایمیل نمایید

‎ ‎

ایمیل : ‏com.dr@yahoo.com